Crest-electronics CRE57000 TRAIN ENGINEER REVOLUTION MANUAL Manual de usuario descargar pdf (Pagina 23)

MENU FUNCTIONS AND NAVIGATION

In this section each menu item is shown along with comments about its use.

The MAIN SET UP menu is accessed by pressing MENU from the main control

screen. To navigate this menu use the p and q keys to select the item that you wish

to edit and press ENTER to access the item submenu.

1.ASSIGN FUNCTION - This Menu

is used to dene individual locomotives.

To navigate this menu use the p and q

keys to select the function that you wish

to change. To change a setting that has a

pre-dened range, use the t and u keys.

Under NAME and ROAD NO. Use the

number and letter keys to add text and

numbers. When programming is complete,

press Menu to return to the Main Menu.

After a new locomotive is dened in this Menu, you must then assign the new

locomotive a Cab Number in Menu 3.ADD MU/SU CAB, before you can control

your newly dened locomotive.

FUNCTION SETTINGS

a.LINK ADDR - The link address for the

locomotive must be chosen. This number

is different for each locomotive and is a

number from “00” to “49”. Use the t and

u keys to select a Link Address. 00 is the

rst available address in the list and should

be used for the rst locomotive. Note that

you can quickly move to address 00 by

pressing the STOP/ENTER key.

b.RxType - This menu item tells the

transmitter which type of receiver is being

dened. OnBoard is the receiver type used

in locomotives while BASE RX is the

receiver type used for stationary functions

such as remote switch control. Use the t

and u keys to select the Receiver Type that you are dening. Once linked, the

receiver type cannot be changed without relinking.

c.NAME - This is where you give your locomotive an easy to identify name.

Use the keypad to type letters or numbers to “Name” the locomotive. Names may

be up to 9 characters long. Something like BNSF GP40 or UP -9 or some similar

description is good. There is a guide to entering text in Appendix “A” (page35).

d.ROAD NO. - Enter the road number of the locomotive being dened. One to

four characters is allowed. This lets you distinguish between two locomotives that

were both named BNSF GP40 for example.

MAIN SET UP

1.ASSIGN FUNCTION¤

2.USAGE OF CAB

3.ADD MU/SU

4.COPY LOCO

5.SYSTEM CONFIGURE

1.ASSIGN FUNCTIONS

a.LINK ADDR [49]

b.RxType [OnBoard]

c.NAME [L49 ]

d.ROAD No. [RdNo]

e.MOMENTUM [ 10%]

f.DELAY [0.0s]

g.MOTOR [NOR]

h.HD DIR [NOR]

i.HD LIGHT [ ON]

j.TOP SPEED [100%]

k.START SPEED[ 0%]

l.AUX FUNC. SETUP

m.LINKING

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 39 40

Comentarios a estos manuales

Sin comentarios

Crest-electronics CRE57000 TRAIN ENGINEER REVOLUTION MANUAL Manual de usuario Pagina 23

Comentarios a estos manuales

Relacionado con productos y manuales para Panel De Control Crest-electronics CRE57000 TRAIN ENGINEER REVOLUTION MANUAL